NiteCore RSW3 Pressure Switch for NITECORE MH12 v2, MH12S, MH25S, MH25 v2, NEW P12, NEW P30 Tac Flashlights

Tactical Accessory for NEW P12, MH12 v2, MH12S, MH25S, MH25 v2
Hunting Accessory for NEW P30
Instant Momentary On
Easy Installation
Preserves Mode Memory
Included in the Box
RSW3 Pressure Switch
Easy Installation
Take your NITECORE NEW P12, MH12 v2, MH12S tactical and NEW P30 long throw flashlights to the next level with the NITECORE RSW3 pressure switch. Just replace the original tailcap with the pressure switch, and position the pressure pad where you can easily access it. The tough durable coil cable is only a foot long when compressed and is tight and secure preventing snags. When fully stretched it can extend up to 22 inches so it work on almost any platform no matter how long.
Easy to Use The RSW3 gives you two new ways to use your light: the side switch on the tail cap or the pressure pad. For constant on and off, click the tail cap side switch. The tail cap switch preserves mode memory and will return your light to the setting you were on before you turned it off. To operate the pressure pad, while the light is off, press and hold the pressure pad for momentary on light and release when you are done. Of course both the NEW P12, MH12 v2 and NEW P30 comes with a side switch on the flashlight body which is used to cycle through the brightness settings and special modes. Add this great accessory to your new light and let the RSW3 help keep you ready for action with no surprises or distractions.